WeldSeal™

    Low-Viscosity Polymer Seals Porosity in Welds

    WeldSeal™ is a high-performance methacrylate formulated for sealing porosity in welds as well as cast iron parts that will contain liquid or gas under pressure. Very low viscosity ( 3-5 mPa·s at 25° C) provides excellent wetting, and enables WeldSeal™ to wick (through capillary action) into pores, welds, and seams and between close-fitting metal surfaces. An anaerobic sealant, it cures in the absence of air (such as when confined in tiny cracks).

    Mixing the sealant's two components creates a translucent red liquid that can be applied with a brush. Once mixed, WeldSeal™ has a pot life of 24-48 hours (longer if refrigerated). Drawing a vacuum improves penetration. As it cures to a pressure-tight seal in about 60 minutes at room temperature, WeldSeal™ forms a densely cross-linked thermoset polymer. Heat accelerates curing. Uncured WeldSeal™ can be rinsed from parts, tools, and brushes with water - no detergents or solvents are required.

    Once cured, WeldSeal™ withstands continuous service temperatures of up to 180° C (355° F) and resists a broad range of chemicals, including oils, glycol, chlorinated and fluorinated solvents, mild caustics, acid solutions, and water. Typical cured hardness is 78 Shore D (ASTM D2240).

    Shelf life is12 months. A low-VOC formulation, WeldSeal™ has a typical solvent content of less than 0.1%.

     

     

     

     

    We are currently seeking distributors for WeldSeal. If you are interested in becoming a distributor and would like more information, contact us by clicking here.

    Technical Specifications

    Other Impregnation Sealants for Metal Castings

    "Speak with an Impregnating Resin Specialist"

    Technical services provided by Ramsey Network Systems, Inc.